Craftsman 152.219110 Manual De Instrucciones página 13

NOTE: P lacethe rackunder the bottom ofthe ring,but
allowenough clearance s o thattherackcanrotate
around thecolumn, T ighten thesetscrew(R), See
Figure4-7,
Figure 4-8
U
I
T
5, SNde the rack (F) and the tabb (M) onto the column
(A), See Figure 4-5,
Figure 4-6
N
I
f
S
8,
Attach the tame raising and bwedng handb (S) on
the worm gear shaft (I) and tighten the set screw
(T) against the flat (U) on the worm gear shaft, See
Figure 4-8,
Figure 4-9
6,
Hace the bottom of the rack (N) inside the flange
(P) on the bottom of the column, See Figure 4-6,
Figure 4-7
E_
jR
9,
Thread the stud of the tame bck handb (V) into the
hob (W) in the rear of the tame bracket, See
Figure 4-9,
7, Place the ring (E) onto the column (A), See Figure
4-7,
13