KALLISTA P70080-00 Guia De Instalacion página 6

Compression
Washer
Fill Valve
Nut
Supply Shank
Compression
Seal
Nut
Washer
Ferrule
Coupling
Nut
Supply
Shut-Off
Valve
Supply Shut-Off Valve
Connection
3. Complete the Installation
NOTE: Your toilet trip lever location may vary from the illustration.
The installation instructions still apply.
Connect the Supply
Install the trip lever if one is not already installed. Follow the
instructions packed with the trip lever.
Connect the supply shut-off valve to the toilet supply shank.
Open the supply shut-off valve slowly to check for leaks. If the
connections have been properly assembled, a slight tightening of
the nuts should stop leakage.
Adjust the Water Level
Squeeze and slide the C-clip on the float rod to adjust the water
level. Slide the C-clip up to raise the water level. Slide the C-clip
down to lower the water level.
Test flush the toilet several times, while checking all connections
for leaks, to ensure proper operation.
For All Installations
Carefully set the cover onto the tank.
Flush the toilet several times and check all connections for leaks.
Periodically check for leaks for several days following the
installation.
1019843-2-A
All manuals and user guides at all-guides.com
C-Clip
Tubing
Adjusting The Water Level
6
Waterline
Kallista