Rear Panel - Edirol UR-80 Manual Del Usuario

Names of Things and What They Do

Rear panel

fig.rear
16.
Power switch (POWER)
Press this switch to turn the power on/off. The power is on when the switch is pressed inward.
17.
AC adaptor connector (DC IN)
Connect the included AC adaptor here
18.
Grounding terminal
Depending on the circumstances of a particular setup, you may experience a discomforting
sensation, or perceive that the surface feels gritty to the touch when you touch this device,
microphones connected to it, or the metal portions of other objects, such as guitars. This is due to
an infinitesimal electrical charge, which is absolutely harmless. However, if you are concerned
about this, connect the ground terminal (see figure) with an external ground. When the unit is
grounded, a slight hum may occur, depending on the particulars of your installation. If you are
unsure of the connection method, contact the nearest Roland Service Center, or an authorized
Roland distributor, as listed on the "Information" page.
Do not connect the grounding terminal to the following locations:
• Water pipe (this can cause electric shock)
• Gas pipe (this can cause explosion or fire)
• Telephone ground or lightning rod (hazardous during electrical storms)
19.
MIDI IN/OUT connectors
Connect these connectors to the MIDI connectors of other MIDI devices to transmit and receive
MIDI messages.
20.
Sampling frequency select switch (SAMPLE RATE)
This switch selects the sampling frequency at which the audio signal will be recorded and played
back.
* If you change the setting of this switch, you must then close all applications and turn the power of the
UR-80 off, then on again.
* If you are using the 96 kHz sample rate, you cannot record and play back simultaneously. You must select
either recording (96 REC) or playback (96 PLAY).
21.
USB connector
Use a USB cable to connect this to your computer.
24
16 17
18 19
20
21 22
23
25 26 27
24