Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Controlling your software
Master Control section
JOG dial
If the Scrub function is on, turning the dial will move the cursor.
Transport buttons
These buttons perform the following functions.
Button
50
fig.ProMasterControl_50
Cursor buttons
These buttons switch the track bank that is controlled by the
UR-80's track controls.
Button
Function buttons
Button
EDIT
[MEM LOCT]
MIXER
[TRANS-
PORT]
IN
[PRE]
OUT
[POST]
UNDO
[EDIT
MODE]
SAVE
[EDIT TOOL]
*Button names in square brackets [ ] indicate that you press the button
while holding down the SHIFT button.
Function
Turn the Scrub function on/off.
Rewind the cursor.
Fast-forward the cursor.
Stop playback/recording.
Start playback.
Start recording.
Function
Return the track bank by 1 track.
Advance the track bank by 1 track.
Move to the next track bank.
Move to the preceding track bank.
Function
[DP] Open the Editor window.
[PT] Open the Track window.
[DP] Open the Marker window.
[PT] Open the Memory Location window.
Open the Mixer window.
Open the Transport window.
Set the current position as the Auto Record Start point
(punch-in).
[DP] Set the current position as the Loop Play Start point.
[PT] Switch pre-roll on/off.
Set the current position as the Auto Record End point
(punch-in).
[DP] Set the current position as the Loop Play End point.
[PT] Switch post-roll on/off.
Undo the previously executed operation.
[DP] Open the Nudge window.
[PT] Switch the edit mode.
Save the current project in a file.
[DP] Open the Track window.
[PT] Switch the Edit tool.
Publicidad
Tabla de contenido
