Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
UR-80 Editor
Assigning a MIDI message
Message Assign window
Controller name
Step 4
Step 5
Step 6
Step 7
LED reception message
assignment area
1.
In the Main window, click the controller to which you want to assign a message.
2.
In the Assign Message area of the Message Assign window, select the type of message that you want to
assign.
3.
According to the type of message you selected, use the fields of the Assign Message area to specify
each parameter of the message. Most parameter fields are specified as a decimal number. However, for
a Free Message, you should input hexadecimal values in the Message input area.
4.
Specify the output port in Output Port.
5.
If the controller is a button, specify the Button Mode.
If the controller is a knob, specify the Knob Mode.
6.
If the controller is a button with LED, specify the LED Mode.
7.
If you specified the LED Mode as "Remote", specify the LED reception message. The LED reception
message field lets you select either Channel Message or Free Message. The parameters are the same
as for a conventional assignment, with the following exceptions.
• Min Value will be the OFF value for the LED reception message.
The LED will turn off when this value is received.
• Max Value will be the ON value for the LED reception message.
The LED will turn on when this value is received.
• There will be no Send LSB check box for RPN or NRPN.
8.
If desired, input a comment in the Comment field.
9.
Click [OK].
78
Step 2
Step 3
Message assignment area
Step 8
Comment input area
Step 9
Publicidad
Tabla de contenido
