Stop The Machine; Empty The Grass Catcher; Operate On Slopes; Operation Tips - GreenWorks GD48LM46 Manual Del Operario

EN
If the machine does not start, remove the battery pack
and examine the mower deck to make sure that:
• no grass catches on the blade.
• the blade can turn freely by hand.
4.2

STOP THE MACHINE

Figure 9.
1. Release the bail switch to stop the machine.
Wait until the blades fully stop before you start the
machine again. Do not quickly turn the machine off
and on.
Always remove the safety key and battery pack after
you complete the work.
4.3

EMPTY THE GRASS CATCHER

Figure 10.
1. Stop the machine.
2. Remove the safety key.
3. Remove the battery pack.
4. Open the rear discharge door and hold it.
5. Hold the grass catcher by its handle and unhook it
from the door rod.
6. Close the rear discharge door.
7. Empty the grass catcher.
4.4

OPERATE ON SLOPES

Do not mow on the slopes with incline more than 15°.
If you are not comfortable, do not mow on a slope.
• Do not go up and down on a slope, mow across the
face of the slope. Be careful when you change the
direction on a slope.
• Monitor the holes, ruts, rocks, and other hidden
objects that can cause you to fall. Remove all
obstacles such as rocks and tree limbs.
• Make sure that your footing is stable. If you are out
of balance, release the bail switch immediately.
• Do not mow near drop-offs, ditches, or
embankments.
4.5

OPERATION TIPS

• Do not try to override the operation of the start
button or bail switch.
NOTE
WARNING
WARNING
WARNING
English
• Do not tilt the machine when you start it.
• Do not put hands or feet near or below the turning
parts.
• Keep the discharge chute clean.
• Do not cut wet grass.
• Higher blade height is necessary for new or thick
grass.
• Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other
debris.
5

MAINTENANCE

Remove the safety key and battery pack from the
machine before maintenance.
Keep the motor and battery pack free from grass,
leaves or too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based
materials touch the plastic parts. Chemicals can cause
damage to the plastic, and make the plastic
unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
Recommended tightening torque (blade): 33-37 Nm.
5.1

GENERAL MAINTENANCE

• Before each use, examine the machine for
damaged, missing, or loose parts such as screws,
nuts, bolts and caps.
• Tighten correctly all the fasteners and caps.
• Clean the machine with a dry cloth. Do not use
water.
5.2

LUBRICATION

Apply sufficient quantity of high grade lubricant to all
bearings. No more bearing lubrication is necessary in
usual operation conditions.
6
WARNING
WARNING
CAUTION
CAUTION
CAUTION
NOTE