ONE=PIECE DOORS
Please readandcomply withthewarnings a nd
reinforcement instructions ontheprevious page.They
applytoone-piece d oorsalso.
• Center t hedoorbracket o nthetopofthedoor,in line
withtheheader b racket a sshown.Mark eitherthe left
andright,or thetopandbottom holes.
•
Metal Doors: Drill 3/16" pilot holes and fasten the
bracket with the 1,/4"-14x5/8 '' self-threading
screws
provided.
• WoodDoors:
Drill 5/16" holes and use 5/16"x2"
carriage bolts, lock washers and nuts (not provided) or
5/16"x1-1/2" lag screws (not provided) depending on
your installation needs.
HARDWARE
SHOWN
ACTUAL
S_ZE
Self-Threading Screw
1/4"-14x5/8"
NOTE: The door bracket may be instafled on the top
edge of the door if required for your instaflafion. (Refer to
the dotted line optional placement drawing.)
HeaderWall
Door
Bracket
Optional
Placement
of Door
Bracket
Vertical
Centerline of
Garage Door
2x4 Support
HORIZONTALAND VERTICAL
REINFORCEMENTIS NEEDED
FOR LIGHTWEIGHTGARAGE
DOORS (FIBERGLASS, ALUMINUM,
STEEL, DOORS WiTH GLASS
PANEL, ETC.). (NOT PROVIDED)
For a door with no exposed framing,
or for the optional installation, use
lag screws 5/16"x1-1/2" (Not Provided)
to fasten door bracket.
Door
Bracket_
__
elf-Threading
Screw
'
1/4"-14x5/8"
i
i
Top of Door
(Inside Garage)
Edge
of Door
Optional
Placement
METAL DOOR
5N/_t,,_18 --_
÷
Lock
Washer
5/16"
Topof Door
Garage)
Top Edge
of Door
Optional
Placement
Carriage Bolt
_
_
5/16"x2"
(Not Provided)
WOOD DOOR
24