Publicidad
Idiomas disponibles
Idiomas disponibles
ALL ONE-PIECE D OORS
1.Assemble
the door arm, Figure 5:
IMPORTANT:
The groove on the straight door arm MUST
face away from the curved door arm,
• Fasten the straight and curved door arm sections
together to the longest possible length (with a 2 or 3
hole overlap).
• With the door closed, connect the straight door arm
section to the door bracket with the 5/16"x1-1/4"
clevis pin.
• Secure with a ring fastener.
2. Adjustment
procedures,
Figure 6:
• On one-piece doors, before connecting the door arm
to the trolley, the travel limits must be adjusted. Limit
adjustment screws are located on the left side panel
as shown on page 27. Follow adjustment procedures
below.
• Open door adjustment:
decrease UP travel limit
- Turn the UP limit adjustment screw counter-clockwise
4 turns.
Press the Door Control push button. The trolley will
travel to the fully open position.
- Manually raise the door to the open position (parallel
to the floor), and lift the door arm to the trolley. The
arm should touch the trolley just in back of the door
arm connector hole. Refer to the fully open
trolley/door arm positions in the illustration. If the arm
does not extend far enough, adjust the limit further.
One full turn equals 2" (5 cm) of trolley travel.
• Closed door adjustment:
decrease
DOWN travel
limit
- Turn the DOWN limit adjustment screw clockwise
4 complete turns.
Figure 6
Inner Trolley
Emerge.L.
-
ncy Release Handle
Closed
I
Door
Inner Trolley
Figure 5
CORRECT
mNCORRECT
Door
Bracket _4_----
Ring
_-'___
Fastener
Nuts
}C_"_'-
__
Lock
5/16"-18
"_/__
Washers
I
t"_
! _
_
_-_,,_.
5/16"
I
I _ tl
ClevisPin
Straight /
_,__------_----___,_ _,_
/
/
//
5/16x1_1J4
Arm
Bo,ts
5/16-18x7/8
_
_
Curved
Door Arm
Press the Door Control push button. The trolley will
travel to the fully closed position.
Manually close the door and lift the door arm to the
trolley. The arm should touch the trolley just ahead of
the door arm connector hole. Refer to the fully closed
trolley/door arm positions in the illustration. If the arm
is behind the connector hole, adjust the limit further.
One full turn equals 2" (5 cm) of trolley travel.
3. Connect
the door arm to the trolley:
• Close the door and join the curved arm to the
connector hole in the trolley with the remaining clevis
pin. It may be necessary to lift the door slightly to make
the connection.
• Secure with a ring fastener.
• Run the opener through a complete travel cycle. If the
door has a slight "backward" slant in full open position
as shown in the illustration, decrease the UP limit until
the door is parallel to the floor.
NOTE: When setting the up limit on the following page, the
door should not have a "backward" slant when fully open
as illustrated below. A slight backward slant will cause
unnecessary bucking and/or jerking operation as the door
is being opened or closed from the fully open position,
Outer Trolley
OpenDoor
26
Backward Slant
(Incorrect)
Publicidad
