Publicidad
Idiomas disponibles
Idiomas disponibles
ELECTRICAL REQUIREMENTS
This appliance
must be grounded.
In the event of an electrical short circuit, grounding
reduces the risk of
electrical shock by providing an escape wire for the electrical current.
This appliance
is equipped
with a cord having a
grounding
wire with a grounding
plug.
The plug must
be plugged
into an outlet that is properly
installed
and grounded.
IMPORTANT
WARNING
An empty refrigerator
can pose a threat to children.
To render the unit harmless we strongly recommend
removing the door prior to disposal.
DO NOT
USE AN
EXTENSION
CORD
Use an exclusive
wall outlet.
Do nat connect your
refrigerator
to extension
cords or together
with any
other appliance
in the same wall
outlet.
DANGER: Risk of child entrapment.
Before you throw
away your old refrigerator
or freezer:
• Take off the doors.
WARNING
- Improper
use of the grounding
plug
can
result
in a risk of electric
shock.
Consult
a qualified
electrician
or serviceman
if the grounding
instructions
are
not completely
understood,
or if doubt
exists
as to
whether
the appliance
is properly
grounded.
• Leave the shelves in place so that children
may not
easily climb inside.
DON'T WAIT! DO IT NOW!
SAVE THESE INSTRUCTIONS!
Remove exterior
and interior packings, wipe the
outside thoroughly
with a soft dry cloth and the inside
with a wet, lukewarm cloth.
Avoid placing the unit in
a narrow
recess or near any heat source, direct
sunlight, or moisture.
Let air circulate
freely around
the unit. Keep the rear of the refrigerator
5 inches
away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the
refrigerator
and any adjacent
wall.
3) Avoid direct sunlight and heat.
Direct sunlight
may affect the acrylic coating.
Heat sources
nearby will cause higher electricity
consumption.
The refrigerating
system in this refrigerator
is a "Frost
Free" system. This type of system requires no user
intervention (i.e. defrosting)
other than selecting
required
cooling temperatures
and the usual care and
maintenance.
To avoid vibration,
the unit must be set level. This is
accomplished
by adjusting the front leveling
leg,
located under the refrigerator.
NOTES:
• This appliance
is intended for FREE-STANDING
INSTALLATION ONLY, and is NOT intended to be
built-in.
• Before connecting this appliance
to electrical
power
supply, leave it to stand for approx.
24 hours, which
will reduce the possibility
of malfunction
in the
cooling system due to transport
handling.
• This appliance
is approved
for INDOOR
USE
ONLY and is NOT intended for outdoor
operation.
IMPORTANT:
Install this appliance
in an area where
the ambient temperature
is between 55°F (13°C) and
110°F (43°C). If the temperature
around the
appliance
is too low or high, cooling ability
will be
affected.
3
Publicidad
