Publicidad
Idiomas disponibles
Idiomas disponibles
Before cleaning, check that the appliance has been switched off for at least 15 minutes and that the power cord has been
disconnected.
Wall installation must take into account the weight of the appliance and, therefore, must be performed taking all precautions
to prevent movements or falls, whether spontaneous or due to accidental knocks and impact, as well as all circumstances that
may constitute a potential hazard for the user or bystanders.
If the required skills and knowledge to perform a wall installation, the safety of which can be guaranteed beyond reasonable
doubt, are lacking, contact specially trained personnel.
Use a damp cloth to clean the product and avoid any abrasive or aggressive cleaning agents; wait for the product to fully dry
before operating it again.
Do not install or use the appliance under direct sunlight or within the range of other ventilation devices, in environments that
are particularly humid and/or saturated with gas, vapours or other suspended substances, in the vicinity of open flames and/or
flammable, combustible or explosive substances.
Do not use in the vicinity of open flames, such as burners, fireplaces, pellet stoves, gas cookers and the like, especially if
extinguishing such flames would result in gas leakage.
Do not use the product to extinguish flames.
Ensure the appliance is connected to a compliant, state-of-the-art installation fitted with a residual current device and thermal
magnetic circuit breaker.
Do not connect the appliance to devices that may cause it to start unsupervised, such as timers, remote controls or
automatisms.
Once unpacked, do not leave the relative materials unsupervised, in particular the plastic bags, as these may be a source of
danger for children or persons with motor and cognitive impairments.
There is no reason to disassemble the appliance, even after its decommissioning. At the end of its service life, it must be sent
for recycling according to the legal requirements in force and described in detail in the next chapter.
Do not modify the appliance for any reason whatsoever: no improvements in performance can be gained by tampering with
its parts. Any modifications shall invalidate the legal guarantee and compliance with the safety requirement, with foreseeable
risks for the user.
Do not remove or tamper with the safety devices fitted to the product.
Do not disconnect the product from the mains by pulling on the cord; rather, firmly grasp and extract the plug with a quick and
decisive movement.
Never submerge any part of the appliance in water or other liquids: do not spray any substances in the vicinity of the appliance
or directly thereon, especially if operating.
Slight smoking or a burning smell during the initial moments of the first start-up is normal and does not constitute a defect:
this emission should cease after a few minutes of operation.
Periodically check the wear of the various parts of the appliance. If damage or defects are found, do not use it and contact
qualified personnel. Pay particular attention to the wear of the power cord.
In anticipation of long periods of non-use of the appliance, it should be disconnected from the mains and not simply switched
off by means of the relative control.
Wait until the blade has exhausted its rotation due to inertia before restarting the appliance following a stop.
During use, it is not advisable to stand close to the appliance for a long time, especially in the direction of the flow: this
circumstance impacts user health and well-being. It can be of great help to start the oscillation mechanism to mitigate the
effects of the air current.
Use the appliance only for the intended purposes as illustrated in this instruction manual.
3. IDENTIFICATION OF PARTS
Check that all the items shown in the picture are present in the packaging: if any items are found to be missing or damaged, do
not proceed with assembly or commissioning in any way and contact your dealer to have the original equipment restored.
7
Publicidad
