Melchioni Family MF 2417PA Manual De Instrucciones página 9

1 Screws and plugs
2 Wall side
3 Rear grille
4 Grille lock nut
5 Blade
4. ASSEMBLY AND COMMISSIONING
A) Place the rear grille (3) against the motor body (11) as described in the previous figure.
B) Screw in the grille lock nut (4) until the rear grille is secured (3).
C) Insert the blade (5), matching the cross-pin of the shaft with the slot behind the blade.
D) Screw the blade locking screw counter-clockwise until it is fully tightened (6).
E) Place the front grille (7) against the rear grille (4) along the edges.
F) Close the clips (9) so that the edges of the two grilles fit together.
G) Fasten the screw and nut on the bottom part of the grilles (8) so that the edges are more firmly held together.
H) Note the distance between the two holes of the mounting plate (10).
I) Drill two holes with the same diameter as the plugs, with the same spacing as the measurement above.
J) Check that the holes are horizontally level. Do not install the appliance in a position that is not perfectly horizontal.
K) Insert the two plugs in the drilled holes, into which two screws must be inserted with a projection of 5-6mm.
L) Position the appliance, inserting the plug screws in the holes of the plate 11.
M) Make the electrical connection, ensuring the cord does not hinder the appliance's movement.
N) Start both rotation and oscillation for a few minutes to check for correct operation.
5. USE
Function keys on both the motor body and remote control:
OFF Stops operation of the appliance.
ON/SPEED Starts rotation and, if pressed in succession, selects the rotation speed from 3 levels, visually indicated by
the corresponding LEDs in the middle row (H=High, M=Medium, L=Low).
SWING When pressed in succession, starts or stops horizontal oscillation of the grille, useful in distributing the
airflow across different areas of the room.
Extra keys on the remote control only:
TIMER When pressed in succession, selects the delay after which the appliance automatically turns off. Each press
equates to a 30-minute interval up to a maximum of 7 hours and 30 minutes. The selected time is
displayed on the motor body via the LEDs in the top row, each of which represents the indicated period
(for example: 0.5H LED on = 30-minute delay, 1H and 4H LEDs on = 5-hour delay). Automatic power-
off can be disabled by pressing the key repeatedly until all the LEDs in the first row turn off.
6 Right-hand blade locking screw
7 Front grille
8 Screw hole and safety nut
9 Grille lock clips
10 Mounting plate
8
11 Motor body
12 Remote Control
13 Front cap