SICE S 65 E Manual De Instrucciones página 103

- centre it inside the cavity of the weight-holder terminal of the measuring arm (fig.20,a,b),
with the backing paper of the adhesive strip facing upwards. Remove the protection (fig.
20c) and turn the terminal so that the adhesive faces the internal surface of the rim.
- Move the sensor until the two reference lines (green) coincide in the relevant windows
on the screen.
- Turn the end of the measuring arm until the adhesive strip of the weight is in line with
the rim surface.
- Press the key (fig.20d) to eject the weight and make it stick to the rim.
- Return the measuring arm to its idle position (fig. 20e).
- Repeat the operations to apply the second balancing weight.
- Perform a test wheel spin to check the balancing accuracy.
The rim surface must be perfectly clean to make the weight stick efficiently to the rim. If
necessary, clean the surface using suitable cleansing products.
a
NOTE: On the wheel balancers for the German
market, the weight must be applied as follows:
apply the weight manually by positioning it so that
its centre line is 15mm back from the contact point
of the measuring head with the rim.
In the machine versions without a weight-holding
device proceed as follows:
- Select the plane where the first balancing weight
is to be applied.
- Turn the wheel until the central element of the
corresponding position indicator (if fitted and
enabled) lights up, together with the laser line.
- Apply the adhesive weight manually in the posi-
tion in which the relative plane was measured,
using the weight centre of mass as a reference.
The screen shows the target, indicating the correct
application position of the adhesive weights as
shown in figure 21.
Operator's Manual S 65 E - S 65 E C
b
d
c
e
20
21
103