Publicidad
Idiomas disponibles
Idiomas disponibles
EnGLIsH
7. Install the chain, guide bar and chain assembly cover
as described in Installing the Guide Bar and Saw Chain,
Replacing the Saw Chain sections and adjust chain tension
properly before use as described in the Adjusting Chain
Tension section.
Optional Accessories
WARNING: Since accessories, other than those offered
by D
WALT, have not been tested with this product, use
e
of such accessories with this tool could be hazardous.
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
appropriate accessories.
Saw Chain Sharpening (Fig. L–N)
CAUTION: Sharp chain. Always wear protective gloves
when handling the chain. The chain is sharp and can cut
you when it is not running.
WARNING: Sharp moving chain. To prevent accidental
operation, ensure that battery is removed from the tool
before performing the following operations. Failure to do
this could result in serious personal injury.
WARNING: Do not over file chain rakers, this will increase
the risk of kickback. If the chain has been sharpened more
than four times, replace it.
Each time the chain is sharpened, it loses some of the low
kickback qualities and extra caution should be used.
It is recommended that a saw chain be sharpened no more
than four times.
nOTE: The cutters will dull immediately if they touch the
ground/dirt or a nail while cutting.
To get the best possible performance from your pruner it is
important to keep the teeth of the saw chain sharp. Follow
these helpful tips for proper saw chain sharpening:
1. For best results use a 11/64" (4.5 mm) file and a file holder or
filing guide to sharpen your saw chain. This will ensure you
always get the correct sharpening angles.
2. Place the file holder flat on the top plate and depth gauge
of the cutter.
3. Keep the correct top plate
your file guide parallel with your chain (file at 60 ° from
chain viewed from the side) as shown in Fig. L.
4. Sharpen cutters on one side of the chain first. File from the
inside of each cutter to the outside. Then turn your saw
around and repeat the processes (2, 3, 4) for cutters on the
other side of the chain.
nOTE: Use a flat file to file the tops of the rakers (portion
of chain link in front of the cutter) so they are about 0.025"
(0.635 mm) below the tips of the cutters as shown in Fig. M.
5. Keep all cutter lengths equal as shown in Fig. N.
6. If damage is present on the chrome surface of the top plates
or side plates, file back until such damage is removed.
CAUTION: After filing, the cutter will be sharp, so use extra
caution during this process.
50
7
WALT-recommended
e
23
filing angle line of 30 ° on
Protecting the Environment
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
w
household waste.
Products and batteries contain materials that can be
recovered or recycled, reducing the demand for raw materials.
Please recycle electrical products and batteries according to local
provisions. Further information is available at www.2helpU.com.
Rechargeable Battery Pack
This long-life battery pack must be recharged when it fails to
produce sufficient power on jobs that were easily done before. At the
end of its technical life, discard it with due care for our environment:
•
Run the battery pack down completely, then remove it from
the tool.
•
Li-Ion cells are recyclable. Take them to your dealer or a
local recycling station. The collected battery packs will be
recycled or disposed of properly.
Publicidad
