WARNING:
This symbol points out important safety instructionswhich, if not followed, could
endanger the personal safety and/or property of yourself and others. Read and follow all
instructionsin this manual before attempting to operate this machine. Failure to comply with these
instructionsmay result in personal injury. When you see this symbol - heed its warning.
WARNING:
Engine Exhaust, some of its constituents,
and certain vehicle
components
contain or emit chemicals
known to State of California to cause cancer
and birth defects or other reproductive
harm.
DANGER:
This machine was built to be operated according to the rules for safe operation in this
manual. As with any type of power equipment, carelessness or error on the part of the operator can
result in serious injury. This machine is capable of amputating hands and feet and throwing objects.
Failure to observe the following safety instructionscould result in serious injury or death.
TRAINING
2.
1.
Read, understand, and follow all instructions on
the machine and in the manual(s) before
attempting to assemble and operate. Keep this
manual in a safe place for future and regular
3.
reference and for ordering replacement parts.
2.
Be familiar with all controls and their proper
operation. Know how to stop the machine and
disengage them quickly.
3.
Never allow children under 16 years old to
operate this machine. Children 16 years old and
4.
over should read and understand the operation
instructions and safety rules in this manual and
should be trained and supervised by a parent.
4.
Never allow adults to operate this machine
5.
without proper instruction.
5.
Keep bystanders, helpers, pets, and children at
6.
least 75 feet from the machine while it is in
operation. Stop machine if anyone enters the
area.
6.
Never run an engine indoors or in a poorly
ventilated area. Engine exhaust contains carbon
monoxide, an odorless and deadly gas.
7.
Do not put hands and feet near rotating parts or in
the feeding chambers and discharge opening.
Contact with the rotating impeller can amputate
fingers, hands, and feet.
8.
Never attempt to unclog either the feed intake or
discharge opening, remove or empty vacuum
bag, or inspect and repair the machine while the
engine is running. Shut the engine off and wait
until all moving parts have come to a complete
stop. Disconnect the spark plug wire and ground
it against the engine.
PREPARATION
1.
Thoroughly inspect the area where the
equipment is to be used. Remove all rocks,
bottles, cans, or other foreign objects which could
be picked up or thrown and cause personal injury
or damage to the machine.
Always wear safety glasses or safety goggles
during operation or while performing an
adjustment or repair, to protect eyes. Thrown
objects which ricochet can cause serious injury to
the eyes.
Wear sturdy, rough-soled work shoes and close-
fitting slacks and shirts. Loose fitting clothes or
jewelry can be caught in movable parts. Never
operate this machine in bare feet or sandals.
Wear leather work gloves when feeding material
in the chipper chute.
Before starting, check all bolts and screws for
proper tightness to be sure the machine is in safe
working condition. Also, visually inspect machine
for any damage at frequent intervals.
Maintain or replace safety and instructions labels,
as necessary.
To avoid personal injury or property damage use
extreme care in handling gasoline. Gasoline is
extremely flammable and the vapors are
explosive. Serious personal injury can occur
when gasoline is spilled on yourself or your
clothes which can ignite. Wash your skin and
change clothes immediately.
a.
Use only an approved gasoline container.
b.
Extinguish all cigarettes, cigars, pipes, and
other sources of ignition.
c.
Never fuel machine indoors.
d.
Never remove gas cap or add while the
engine is hot or running.
e.
Allow engine to cool at least two minutes
before refueling.
f.
Never over fill fuel tank. Fill tank to no more
than 1/2 inch below bottom of filler neck to
provide space for fuel expansion.
g.
Replace gasoline cap and tighten securely.
h.
If gasoline is spilled, wipe it off the engine
and equipment. Move machine to another
area. Wait 5 minutes before starting the
engine.