Descargar Imprimir esta página

Sears Craftsman EZ3 917.259581 Manual Del Propietário página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

,
Connect the other end of the BLACK cable to good
CHASSIS GROUND,
away from fuel tank and battery.
FO REMOVE CABLES, REVERSE ORDER --
,
BLACK cable first from chassis and then from the fully
charged battery.
0
RED cable last from both batteries.
CE
A
E
TO REPLACE
FUSE
Replace with 30 amp automotive4ype
plugqn fuse. The
fuse holder is !ocated behind the dash.
"POSITIVE"
(+}
"NEGATIVE"
(-)
dY
L.N. PANEL
BOLT
FiG. 29
TO REPLACE
HEADUGHT
BULB
,
Raise hood.
,
Pull bulb holder out of the hole in the backside of the
grill.
Replace bulb in holder and push bulb holder securely
back into the hole in the backside of the grill.
Close hood.
TO REMOVE
HOOD AND GRILL
ASSEMBLY
(See Fig. 30)
Raise hood°
o
Unsnap headlight wire connector.
Stand in front of tractor. G rasp hood at sides, ti!t toward
engine and lift off of tractor.
To replace, reverse above procedures.
t
t
,.\
/
HEADLIGHT
W_RE
CONNECTOR
FIG. 30
_NTERLOCKS
AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
Check wiring.
See electrical wiring diagram in the
Repair Parts section of this manual
25

Publicidad

loading