Publicidad
Idiomas disponibles
Idiomas disponibles
11. Stop the engine. Wait 30 seconds and check
the oil level again. If necessary, also see
"check/top-up" (par. 7.3.1).
IMPORTANT Hand the spent oil over to
a disposal facility in accordance with local
provisions.
7.4 CLEANING
Carry out cleaning operations with the
machine switched off. Do not try to remove
snow from the discharge without firstly:
• Releasing the auger control.
• Turning off the engine.
• Removing the ignition key.
Always clean the machine after use. To clean
the machine adhere to the instructions provided
below:
• Remove the snow residue from the discharge
chute and from the machine, using brushes or
compressed air.
• Clean the engine with a brush and/or
compressed air.
• Do not spray water directly onto the engine.
• After cleaning using water, start the machine
and auger to remove any water which may
otherwise end up in the bearings and cause
damage.
IMPORTANT Never use high-pressure water
jets. It could damage the electrical components.
7.5 SPARK PLUG
For spark plug operations, contact the Dealer
or Authorised Assistance Centre. Consult the
Maintenance T able and the Problems Identification
Table for any intervention on the spark plug.
7.6 CARBURETTOR
The carburettor is pre-tuned by the manufacturer.
Consult the Problems Identification Table to check
when intervention is required on the carburettor
(chap. 12).
7.7 NUTS AND BOLTS
• Keep all nuts, bolts and screws tight to be sure
the equipment is in safe working condition.
• At frequent intervals check all fasteners on the
discharge chute to ensure they are securely
tightened.
8. STORAGE
When you intend to put your machine away for
more than 30 days:
1. Empty the fuel supply circuit:
– Start the machine's engine and leave it
running until it runs out of fuel.
2. Change the engine oil if this operation has not
been done in the last three months.
3. Clean the snow thrower thoroughly.
4. Check for any damage. If necessary, see to
the necessary repairs.
5. If the paintwork is damaged, touch it up to
prevent rust.
6. Protect any exposed metal surfaces from rust.
7. Store the snow thrower indoors if possible
9. ASSISTANCE AND REPAIRS
This manual provides all the necessary
information to run the machine and for correct
basic maintenance operations which can be
performed by the user. Any regulations and
maintenance operations not described herein
must be carried out by your Dealer or Authorized
Service Centre, which have the necessary
knowledge and equipment to ensure that the
work is carried out correctly, maintaining the
correct degree of safety and the original operating
conditions of the machine.
Any operations performed in unauthorized centres
or by unqualified persons will totally invalidate the
Warranty and all obligations and responsibilities
of the Manufacturer.
• Only authorized service workshops can carry
out guaranteed repairs and maintenance.
• The authorized service workshops only use
genuine spare parts. Genuine spare parts and
accessories have been designed specifically for
machines.
• Non-genuine spare parts and accessories are
not approved. Use of non-genuine spare parts
and accessories cause the warranty to expire.
• It is advisable to send your machine once a year
to an authorized service workshop for servicing,
assistance and safety device inspection.
10. WARRANTY COVERAGE
The warranty covers all material and manufacturing
defects. The user must follow all the instructions
provided in the accompanying documentation.
The warranty does not cover damages caused by:
• Failure
to
documentation accompanying the machine.
EN - 9
become
familiar
with
the
Publicidad
