WerkaPro TP1610009 Instrucciones De Uso página 17

support (IMPORTANT: make sure you insert the adjustment block into the adjustment hole on the guide bar)
4. Placez Place the chain around the drive sprocket, then along the top groove of the guide bar and around the nose
of the guide bar. Note: Make sure the cutting edges of the chain are pointing in the right direction. Position the
chain so that the cutting edges are on top of the nose of the guide bar (see figure 1).
5. Adjust the saw chain tension. Follow the steps under Chain tension adjustments
6. The oiler inside the pole saw's fuel tank. (IMPORTANT: Fill, you must tighten the cap) (See Figure 2)
Post saw information
SAW CHAIN TENSION
WARNING: Disconnect chain saw from power source before adjusting saw chain tension. Serious injury or death could
result from bodily contact with a moving chain.
WARNING: The cutting edges on the chain are sharp. Use protective gloves when handling the chain.
WARNING: When cleaning the saw body,
do not immerse the saw in any liquid
-
do not use products containing ammonia, chlorine or abrasives
-
do not use chlorinated cleaning solvents, carbon tetrachloride, paraffin or petrol (Note: The saw chain tension
-
is correctly adjusted at the factory. A new chain will stretch. Check the chain tension frequently (after
disconnecting the plug from the power source) during the first 2 hours of operation. Allow the chain to cool.
Steps below to check saw chain tension).
1. Unplug the chainsaw from the power source.
2. Place the chainsaw on a firm surface to check the chain tension.
Figure 1
Figure 2