GE JVM1660CB005 Instrucciones De Instalación página 20

Installation Instructions
C3.| CHECK MICROWAVE ASSEMBLY
Exhaust Adaptor (absent
on models shipped for
recirculation exhaust)
<< SS P e " Back of
es "4 Microwave
_ io
* Place the microwave in its upright position, with the
top of the unit facing up.
* The microwave oven may be shipped assembled for
top exhaust (adaptor installed) or for recirculation
exhaust (adaptor absent).
* If the microwave was shipped for recirculation
exhaust, skip to C5. If shipped for top exhaust,
proceed with C4.
C4.| ADAPTING MICROWAVE
BLOWER FOR RECIRCULATION
plate to the microwave.
microwave.
SA Back of
w e iO ~~- Microwave
.
Slide exhaust adaptor to one side and remove it.
NOTE: The exhaust adaptor with damper is not
needed for recirculating models. You may want to
save them for possible future use.
ee
4 Remove and save the screw that holds the blower
motor to the microwave.
Blower Plate
Back of
™*- Microwave
peed On
O me Blower Motor
we Screw
20
Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust the
blower unit.
Xx
=
=
[6 | Roll the blower unit 90° so that fan blade openings
are facing toward the front of the microwave.
BEFORE: Fan Blade
Openings Facing Up
AFTER: Fan Blade
Openings Facing
Forward
79 ey
NOTE: Make sure wires remain routed in the
grooves of the motor frame.