Publicidad
Idiomas disponibles
Idiomas disponibles
IN240100AV |
OIL PORT HOLE
ON THIS SEN.
TOOL SHANK
ANVIL
FORWARD/
REVERSE
BUTTON
EXHAUST PORT-
TRIGGER
REGULATOR
7
AIS INÉÉT
A
ee ee ee,
Figure 1
the air motor and the impact mechanism. Follow the
outlined procedures and refer to Figure 1 for details.
Campbell Hausfeld air tool oil (ST127000AY) is recom-
mended because this oil cleans, lubricates and inhibits
rust all in one step.
Air Motor Lubrication.
'Disconnect the impact wrench from the air supply.
_ . Turn the impact wrench upside down.
Simultaneously (at the same time), pull the trigger
and pour a teaspoon of Campbell Hausfeld oil in the
air inlet. Then, push the forward and reverse button
in both directions.
A WARNING À
AFTER AN AIR TOOL
HAS BEEN
LUBRICATED,
OIL WILL DISCHARGE THROUGH
THE EXHAUST
PORT
DURING
THE
FIRST
FEW
SECONDS
OF
© OPERATION.
THUS, THE EXHAUST PORT MUST
: BE COVERED
WITH A TOWEL
BEFORE
APPLY-
: ING AIR PRESSURE.
FAILURE
TO COVER
THE
|
rtf aa
PORT
CAN
RESULT
IN SERIOUS
IN-
MODEL PL1502, PL1536, PL1556 AND PL1557
OIL PORT
TRIGGER
HOLE
EXHAUST POR
FORWARD!
REVERSE
BUTTON
impact Wrench Features
reverse directions for 20 to 30 seconds. Oil will
discharge from the exhaust port when air pressure
is applied.
Impact Mechanism Lubrication.
The impact mechanism should be lubricated monthly.
A. WARNING À
DISCONNECT THE IMPACT WRENCH
FROM THE
AIR SUPPLY BEFORE LUBRICATING.
1.
Disconnect the impact wrench from the air supply.
2.
Remove the slotted screw or allen head screw from
the oil port hole on the right side of the tool that has
"OIL" stamped below the hole for models PL1502,
PL1536 and PL1556.
For model PL1557, the allen
head screw is located on the left hand side of the
tool near the extended anvil.
3.
Put three teaspoons of Campbell Hausfeld air tool
oil in the oil port hole. Replace the screw.
4.
Reconnect the air supply to the impact wrench and
run for 20 to 30 seconds. Lubricate the entire impact
mechanism by rotating the tool upside down and
sideways while running the tool.
lubrication.
o
Publicidad
