Silverline 580430 Manual De Instrucciones página 7

580430
Operation
Note: It is advised that you practice using this tool on a piece of scrap wood. Try it in both orbital modes
(see 'Changing orbital mode') to familiarise yourself with each.
1. Grip the Handle (4) firmly with one hand, so your thumb can operate the Speed Control (3)
2. Hold the Body Cover (1) with your other hand, to control the tool and apply pressure to the
workpiece
3. Firstly squeeze the Speed Control gently to familiarise yourself to the way the tool operates
Note: You can adjust the speed of the tool by adjusting the pressure you apply to the Speed Control.
4. Begin by holding the tool gently against the workpiece, and slowly building up speed and pressure
WARNING: The friction between abrasive and material will cause heat. Check the workpiece
frequently to ensure it does not burn.
WARNING: Be aware that air tools may hold residual pressure after use. Always bleed air pressure
from the tool after shutting off air supply.
Accessories
Accessories for this tool including adhesive sanding discs are available from your Silverline stockist.
Spare parts can be obtained from your Silverline dealer or www.toolsparesonline.com
Maintenance
WARNING: Always disconnect from the air supply and depressurise before cleaning or carrying
out any maintenance.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten
the machine's service life. Clean the body of your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it should be noted that when
an air tool fails to work it is generally because the internal workings have corroded due to dirty, wet air
and failure to follow the instructions given below.
Daily maintenance procedure
If an inline lubricator is not fitted to the air supply, the tool must be manually lubricated:
1. Disconnect from the air supply
2. Pour 3-4 drops of oil into the air intake
3. Operate the machine at low speed to thoroughly lubricate all internal workings
• If the machine is in constant use or used for long periods at a time, repeat the above procedure up
to 3 times per day
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL ENGINE OIL
• Failure to comply with the operating and maintenance instructions may invalidate the guarantee
Air Sander & Polisher 150mm
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Contact
For technical or repair service advice, please contact the helpline on (+44) 1935 382 222
Web: www.silverlinetools.com
UK Address:
Toolstream Ltd.
Boundary Way
Lufton Trading Estate
Yeovil, Somerset
BA22 8HZ, United Kingdom
EU Address:
Toolstream B.V.
Holtum-Noordweg 11
Unit 4
6121 RE Born
The Netherlands
Disposal
• As with other power tools, air tools should not be disposed of with household waste
• Air tools may contain traces of tool oil and other lubricants and so must be recycled accordingly
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
silverlinetools.com
7