Descargar Imprimir esta página

WerkaPro 10696 Instrucciones De Uso página 9

Desbrozadora eléctrica

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 12
Technical data
Voltage / Frequency
Max. power
Max. temperature
Cable length
Net Weight
Operation
Connect the appliance to a power socket (230V alternating current) using an extension cable.
Switch the appliance on by pressing the ON/OFF switch3.
The full operating temperature is reached after approx. 1 minute.
To kill weeds, now place the cone nozzle8 onto the plant to be treated for around 5-10 seconds depending on the type
of plant.
For taller plants, first only heat the upper section of the plant briefly and then place the cone nozzle 8 against the shrunken
plant for approx. 5-10seconds.
Notes
This appliance is particularly suitable for removing weeds.
Weed killing is most effective at an early stage of vegetation growth.
The most suitable time is during spring.
The treatment is at its most intensive the younger the plant is. However, the success of the measure is not immediately
visible.
The visible section of the plant can also be burnt off with a longer exposure time/treatment.
Plants do not react immediately to the heat radiation with recommended treatment time. The following applies as a basic
principle: young, soft-leaved plants react most sensitively to treatment. They are subsequently no longer capable of
survival.
Older plants with hard leaves such as thistles must be treated more frequently at an interval of between 1 and 2 weeks
in order to make them dry out.
To begin with, overgrown areas must be treated several times at short intervals in order to produce long-term success.
After this, treatment at longer intervals is sufficient.
Burning the plants off completely is not essential. During heating, the leaf cells dry out and the weed will die.
Repeated treatment of certain types of weed may be necessary.
Shutting down
Release the ON/OFF switch 3.
Always replace the appliance on the stand after use on a level, fireproof underlay until the hot components have
cooled down.
Lighting charcoal
WARNING!
Do not use any lighter fluid.
As soon as the charcoal has started to glow, remove the appliance from the charcoal.
De-waxing
Use the porduct with suitable caution to remove residual wax from skis/snowboards or candle holders.
220V-240V~ , 50Hz
2000 W
600 °C
1.8 m
0.95 kg

Publicidad

loading

Este manual también es adecuado para:

Dt4001