Ghibli FRECCIA 30 E 45 Uso Y Mantenimiento página 27

7.1.b - Electrical connection
- Introduce the cable (42) of an extension
in the tear-proff hook (28) locking it as
shown in figure.
- Connect the outlet (43) of the extension
cord (42) with the plug (16) of the ma-
chine.
- Connect the power cord to an outlet hav-
ing minimum capacity of 10A.
WARNING:
- Make sure that the mains system is
equipped with an RCD (circuit breaker).
- Unwind the electric power cable com-
pletely before operating the appliance.
- Use an electrical extension lead only
if in perfect condition; ensure that the
section is appropriate for the appliance
power rating.
- Never let the power cable run over
sharp edges and do not tread on it.
7.1.c - Preparing the machine and
choosing the cycle (Figg. 6-9)
- Press the switch (34) and turn the key
(36) to position "1".
- Release the lever (3 Fig. 9) and lower it;
the floor squeegee (11 Fig. 9) is lowered.
- Press down on the pedal (19 Fig. 9), re-
lease it from its coupling and lift it, the
brush (10 Fig. 9) will be lowered.
Working cycle:
- The machine can perform 4 working cy-
cles:
Drying only cycle:
- In order to perform the drying cycle alone,
press the switch (35). The suction unit will
activate.
Brushing only cycle:
- To perform only the brushing cycle, press
the switch (38) to enable brush rotation.
Press the lever (20) to start brush rota-
tion.
FRECCIA30 E 45_27lingue_2ed_09-2013.indd 7
Washing, brushing cycle:
- Press the switch (38) to enable brush
rotation, press the switch (39) to enable
water dispensing.
Washing, brushing, drying cycle:
- Press the switch (35) to start the aspira-
tor, switch (38) to enable brush rotation
and press the switch (39) to enable water
dispensing.
Press the controls located on the handle
to start brush rotation and water dispens-
ing.
7.1.d - Using the machine (Fig. 1)
- After turning the machine on and se-
lecting the cycle, the cleaning operation
starts, pushing the machine with the help
of the handle (1).
N.B.:
To avoid ruining particularly delicate floors,
do not use the machine when stopped with
brush rotation activated.
N.B.:
The correct way of cleaning and drying the
floor is to move the machine forwards. Mov-
ing the machine backwards damages the
blades as well as not allowing correct aspira-
tion of the water present on the floor.
- If necessary, adjust the quantity of wash-
ing water using the tap (4 Fig. 1).
7.1.e - End of use and switching off
(Figg. 6-10)
- Once the cleaning operations have been
completed, do not shut off the machine
immediately: use switches (39) and (38)
to deactivate water dispensing and brush
rotation.
- Lift up the brush by pressing the pedal
(19 Fig. 10) as far as it will go, fitting it in
the designated slot.
- Continue with the aspirator inserted to
EN-7
EN
30/09/13 14:36