Princess Starck 6001 Manual De Instrucciones página 7

Starck_6001_IB_22-3-04 3/22/04 3:28 PM Page 7
hairdryer face down and snap the air output end onto the circular opening on top of the storage
box / stand.
TO REMOVE THE HAIRDRYER FROM THE STORAGE BOX / STAND:
With one hand, hold the storage box cover while carefully, but firmly, lifting the dryer from the
storage box / stand. Open the handle and return it to the correct position for use.
Never store the hairdryer while it is hot or still plugged in. Never wrap the cord around the
appliance. Never hang the unit by the cord. Do not put any stress on the cord where it enters the
unit, as it could cause the cord to fray and break.
USER MAINTENANCE INSTRUCTIONS
This appliance contains no user serviceable parts. Do not try to repair this appliance yourself. Refer
service, if necessary, to qualified service personnel.
TO CLEAN
If cleaning is needed, unplug the hairdryer and allow it to cool. Use a soft, damp cloth to wipe the
outside of the hairdryer.
NOTE: If the unit is not functioning properly, turn it off, unplug and allow to cool. Check the air
intake grill to make sure it is free from dust and debris. If it is not clear, remove the filter and clean
with a small brush and then try to turn it on again.
CAUTION: Do not allow water or any other liquid to get into the hairdryer.
CAUTION: Check the air intake vent to make sure it is free from dust and debris. The intake grille
should be cleaned occasionally with a small brush to prevent fire hazards.
TO DETACH AIR INTAKE FILTER
Position your fingers along the inside edge of the air intake filter (see figure 1 above). Apply
fingertip pressure on the inside edge and rotate the air intake filter approximately one-quarter turn
anti-clockwise (see figure 2). Turn the hairdryer so that the air intake filter is facing downward; the
air intake filter should fall into your hand.
TO ATTACH AIR INTAKE FILTER
Align the groove on the inside surface of the air intake filter with the tab on the rear of the
hairdryer (see figure 3). Insert the air intake filter and turn approximately one quarter turn clockwise
to tighten.
HOW TO USE YOUR HAIRDRYER
IMPORTANT
During the first few minutes of initial use, you may notice smoke and a slight odour. This is normal
and will quickly disappear.
1. Remove the hairdryer from its stand.
2. Plug the dryer into a 230V AC socket.
3. Set dryer to desired setting (LOW or COOL). Use the dryer through a section of hair
at a time. Aim the hot air flow at your hair, not your scalp and dry/style your hair.
CAUTION:
• NEVER block air intake vents, as this will cause the unit to overheat. Keep air intake vents
unobstructed and free from hair while drying.
• The heating section should never be touched, as it may be hot and cause burns.
7