FITFIU SURFING Manual Del Usuario página 39

BATTERY CHARGING
1. Make sure the scooter is turned off.
2. Insert the battery charger connector into the charging port (right side of rear wheel).
3. Connect the charger to a standard power supply. When charging, the indicator will light red. The charger may
heat up during recharging, this is normal and does not have to be a cause for concern.
4. When charging is complete, the charger indicator will turn green. Disconnect the charger from the power
supply and remove the battery connector from the charging port.
NOTE: The battery must be charged before first use. It takes approximately 5 hours to charge the
battery from discharged to fully charged.
MAINTENANCE
ATTENTION: Make sure the scooter is turned off before starting any maintenance work.
• Clean the scooter using only a soft dry cloth.
• DO NOT use chemicals, solvents, abrasives, or any type of liquid to clean the scooter because they may damage
electrical components or surface finishes.
• Do not use a high pressure water gun to clean the product.
IDENTIFICATION AND SOLUTION OF PROBLEMS
The following information can help identify a problem and rectify it.
Problem
•
•
The tyre does not
work when the
•
speed switch is
pressed
•
•
There's a lot of
•
noise in driving
Cause
The controller is damaged.
The engine's broken.
Non-zero start configuration.
The electronic brake cables are
damaged.
There's some loose piece.
The motor has been used for too
long.
ELECTRIC SCOOTER SURFING
• Contact the Official Technical Service.
• Contact the Official Technical Service.
• Reset the non-zero to zero unit icon on the
LCD controller.
• Check the cables that connected to the brake
under the LCD panel for damage or short
circuits.
• Tighten the loose part.
•
Replace the engine with a new one.
39
Solution
EN