Publicidad
Idiomas disponibles
Idiomas disponibles
ConnectDoorArm to Tro//ey(Continued)
ALL0NE-PIECEDOORS
IMPORTANT." Thegroove on the straight door arm MUST face
away from the curved door arm (Figure 5).
1. Close the door. Disconnect the trolley by pulling the emergency
releasehandle.
2. Fastenthe straight door arm and the curved door arm together
to the longest possible length (with a 2 or 3 hole overlap).
3. Attach the straight door arm to the door bracket using the
5/16"x1-1/4" clevis pin. Secure with the ring fastener.
4. Attach the curved door arm to the trolley using the 5/16"x1"
clevis pin. Secure with the ring fastener.
5. Pull the emergency release handle toward the garage door
opener until the trolley releasearm is horizontal.
Figure5
CORRECT
INCORRECT
Trolley
Pulley
Stop Bolt
Inner
Trolley
Outer
Trolley
Door
Bracket
Ring
Ring
Nuts
Fastener_
Fastener
5/16"-18
strai0ht
Q
DoorArm
Lock
Washers-------_
,
5/16"
Clevis Pin
5/16"x 1-1/4"
DoorArm
Bolts
5/16"-18x7/8"
Emergency
Release Handle
Clevis Pin
5/16"xl"
INSTALLATION
STEP
10
Attach the Warning Labels
1. Attach the entrapment warning label on the wall near the door
control with tacks or staples.
2. Attach the manual release/safetyreverse test label in a visible
location on the inside of the garage door.
21
Publicidad
