Rosenbauer RTE FX Instrucciones De Servicio página 5

2 Introduction
2.1 Introduction
This manual is to be read through carefully and all regulations and advice
observed before commissioning the product.
Also observe the documents of the corresponding manufacturers supplied
in addition to this manual (e.g. operation manual of the power generator,
rescue equipment, fire and safety equipment).
All persons, who deal with the operation and maintenance of the product,
must be correspondingly qualified, have read this manual fully and follow it
exactly.
The manual is always to be kept at the site of operation of the product.
2.2 Liability and injury
Due to the information in this manual Rosenbauer fundamentally accepts
no liability for direct damage or consequential damage, which arise from in-
correct operation or maintenance, as well as by unauthorised changes of
components or this manual.
The product may only be operated by persons who are familiar with the
manual, the product as well as the national laws, guidelines and regulations
pertaining to work, safety and accident prevention.
Rosenbauer assumes no responsibility for injury to persons or material
damage, which are caused by untrained personnel, also through non-com-
pliance with the regulations regarding work, safety and accident prevention.
If this manual contains a technical error or a typographical error,
Rosenbauer reserves the right to make change at any time and without no-
tice.
This manual may contains figures and descriptions, that are not built into
the delivered product.
No claims may be made for products that have already been delivered from
the information, figures and descriptions in this manual.
For your own safety only use spare parts and accessory products from
Rosenbauer. Rosenbauer accepts no liability for the use of other products
and the resulting damage!
Check the delivery immediately for transport damage and completeness.
•
•
•
2.3 Identification
Identifying the serial number is important when referring to the manufactur-
er in regards to part and technical issues.
The serial number of the O-stream nozzle is visible on the underside of the
flow rate adjustment.
Faults and damages must be documented in writing immediately.
Photograph damaged components.
Send written damage report to the manufacturer - see chapter "Im-
print".
Introduction
Introduction
EN
DE
FR
IT
ES
NL
NO
HU
PL
L10
L11
L12
5 / 173