STEINEL US 360 COM1 Manual De Instrucciones página 20

GB
Dear Customer,
Congratulations on purchasing
your new STEINEL sensor and
thank you for the confidence
you have shown in us. You
have chosen a high-quality
1. Safety precautions
• Disconnect the power sup-
ply before attempting any
work on the sensor!
• During installation, the elec-
trical wiring you are con-
necting must be dead.
Therefore, switch off the
power first and use a volt-
age tester to make sure the
wiring is off circuit.
2. Assembly / Installation 13. (see fig. on page 3)
The sensor is only intended for
concealed, indoor installation in
ceilings. A clamping-type ceiling
adapter or surface-
mounting adapter is not
included.
3. System Components
1. Load module
2. Sensor module
3. Sensor base
4. Dip switches
(1) Normal / test mode
(2) Semi- / fully automatic
mode
(3) Button / switch
(4) ON / ON-OFF button
(5) DIM option
Constant lighting control
ON / OFF
product that has been manu-
factured, tested and packed
with the greatest care. Please
familiarise yourself with these
instructions before attempting
to install the sensor because
prolonged, reliable and
• Installing the sensor involves
work on the mains power
supply. This work must
therefore be carried out pro-
fessionally in accordance
with the applicable national
wiring regulations and elec-
trical operating conditions
(VDE 0100).
Sensor and load module come
ready assembled and must be
plugged together after fitting
the load module and setting the
potentiometers / dip switches.
The sensor module must now
be locked in place with the
catch mechanism l, using a
screwdriver if necessary.
(6)(7)(8)
Trigger mode
(DT Quattro only)
5. Light-level setting
6. Time setting
Switching output 1
7. HVAC stay-ON time
Switching output 2
8. HVAC switch-ON delay
Switching output 2
9. Reach setting
- 20 -
trouble-free operation will only
be ensured if it is fitted and
used properly.
We hope your new STEINEL
sensor will bring you lasting
pleasure.
• Terminal B 1, B 2 is a
switching contact for
low-energy circuits, not
more than 1 A. This must be
protected a fuse of the ap-
propriate rating.
• Only electronic ballasts with
a floating control signal may
be used at DIM 1-10 V con-
trol output.
Accessories:
Kaiser hollow-wall box,
EAN no.: 4007841 000370
Clamping-type ceiling adapter,
EAN no.: 4007841 002855
Surface-mounting adapter,
EAN no.: 4007841 000363
Guard cage,
EAN no.: 4007841 003036
Service remote control,
EAN no.: 4007841 559410
User remote control,
EAN no.: 4007841 592806
10.1 Kaiser hollow-wall box,
optional
10.2 Clamping-type ceiling
adapter, optional
11. Surface-mounting adapter
IP 54, optional
12. Locking mechanism
13. Assembly / Installation
14. Parallel-connected
configurations
15. Stay-ON time Orientation
light DIM option