30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
(Models with an Electric Oven and a Gas Cooktop)
important Notes to the Installer
1.
Read all instructions contained in these installation
instructions before installing range.
2.
Remove all packing material from the oven compartments
before connecting the gas and electrical supply to the
range.
Observe all governing codes and ordinances.
Be sure to leave these instructions with the consumer.
Note: For operation at 2000 ft. elevations above see
level, appliance rating shall be reduced by 4 percent for
each additional 1000 ft.
important Note to the Consumer
Keep these instructions with your Use & Care Guide for
future reference.
IMPORTANT SAFETY
INSTRUCTIONS
Installation of this range must conform with local codes
or, in the absence of local codes, with the National Fuel
Gas Code ANSI Z223.1—latest edition.
This range has been design certified by CSA international.
As with any appliance using gas and generating heat,
there are certain safety precautions you should follow. You
will find them in the Use and Care Guide, read it carefully.
e¢ Be sure your range is installed and grounded
properly
by a qualified
installer or service
technician.
e This range
must
be electrically grounded
in
accordance with local codes or, in their absence,
with the National Electrical Code ANSI/NFPA No.
70—latest edition. See Grounding Instructions.
* The installation of appliances designed for manufactured
(mobile) home installation must conform with Manufactured
Home Construction and Safety Standard, title 24CFR, part
3280 [Formerly the Federal Standard for Mobile Home
Construction
and Safety, title 24, HUD
(part 280)] or
when such standard is not applicable, the Standard for
Manufactured
Home
Installation
1982 (Manufactured
Home Sites, Communities and Setups), ANSI Z225.1/NFPA
501A-latest edition, or with local codes.
Pal
©° reduce the risk of tipping
° All ranges
of the range, the range
can tip.
must be secured by properly
° Injury to
installed anti-tip bracket
persons
provided with the range.
could result. | } check if the bracket is
e Install anti-_
| installed properly, grasp the
tip device
top rear edge of the range
packed with
and carefully tilt it forward
range.
to make sure the range is
anchored.
e Make sure the wall coverings around the range
can withstand the heat generated by the range.
¢ Before installing the range in an area covered with
linoleum or any other synthetic floor covering,
make sure the floor covering can withstand heat
at least 90°F above room temperature without
shrinking, warping or discoloring. Do not install the
range over carpeting unless you place an insulating pad
or sheet of 1/4"(10,16cm) thick plywood between the
range and carpeting.
¢ Do not obstruct the flow of combustion air at the
oven vent nor around the base or beneath the
lower front panel of the range. Avoid touching the
vent openings or nearby surfaces as they may become
hot while the oven is in operation. This range requires
fresh air for proper burner combustion.
Never
leave
children
alone
or
unattended in the area where an appliance is in use.
As children grow, teach them the proper, safe use of all
appliances. Never leave the oven door open when the
range is unattended.
NWEGRINTE
stepping, leaning or sitting on the
doors or drawers of this range can result in serious
injuries and can also cause damage to the range.
¢ Do not store items of interest to children in the
cabinets above the range. Children could be seriously
burned climbing on the range to reach items.
¢ To eliminate the need to reach over the surface
burners, cabinet storage space above the burners
should be avoided.
¢ Adjust surface burner flame size so it does not
extend beyond the edge of the cooking utensil.
Excessive flame is hazardous.
¢ Do not use the oven as a storage space. This creates
a potentially hazardous situation.
¢ Never use your range for warming or heating the
room. Prolonged use of the range without adequate
ventilation can be dangerous.
e Do not store or use gasoline or other flammable
vapors and liquids near this or any other appliance.
Explosions or fires could result.
* In the event of an electrical power outage, the surface
burners can be lit manually. To light a surface burner,
hold a lit match to the burner head and slowly turn
the Surface Control knob to LITE. Use caution when
lighting surface burners manually.
¢ Reset all controls to the "off" position after using
a programmable timing operation.
FOR MODELS
WITH SELF-CLEAN
FEATURE:
e Remove broiler pan, food and other utensils before
self-cleaning the oven. Wipe up excess spillage.
Follow the precieaning instructions in the Use and Care
Guide.