Publicidad
Idiomas disponibles
Idiomas disponibles
SPECIFICATIONS
V
l o
a t
g
e
F /
e r
q
u
e
n
y c
Power
N
o
o l
a
d
s
p
e
e
d
C
l l o
t e
s
z i
e
Net weight
FUNCTIONAL DESCRIPTION
1) Adjusting bit protrusion (Fig, 1)
To adjust the bit protrusion, loosen the locking lever
and move the tool base up or down as desired by
turning the adjusting screw. After adjusting, tighten the
locking lever firmly to secure the tool base.
NOTE: When the tool is not secured even if the locking
lever is tightened, tighten the hex nut and then tighten
the locking lever.
1. Bit protrusion
2. Tool case
3. Scale
4. Locking lever
5. Adjusting screw
6. Hex nut
2) Switch action (Fig, 2)
CAUTION:
Before plugging in the tool, always check to see that
the tool is switched off.
To start the tool, press the "ON (I )" side of the switch.
To stop the tool, press the "OFF(O)"side of the switch.
1. Switch
3. ON (I) side
3) Speed adjusting dial (Fig, 3)
120V/60HZ
710w
12000-30000r/min
6.35mm
1.8KGS
2. OFF (O) side
The tool speed can be changed by turning the speed
adjusting dial to a given number setting from 1 to 6.
Higher speed is obtained when the dial is turned in the
direction of number 6. And lower speed is obtained
when it is turned in the direction of number 1.
This allows the ideal speed to be selected for optimum
material processing, i.e. the speed can be correctly
adjusted to suit the material and bit diameter.
Refer to the table for the relationship between the
number settings on the dial and the approximate tools
peed.
Number
1
2
3
4
5
6
CAUTION:
• If the tool is operated continuously at low speeds for
a long time, the motor will get overloaded, resulting in
tool malfunction.
• The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or the
speed adjusting function may no longer work
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Installing or removing trimmer bit (Fig. 4,5)
CAUTION:
• Do not tighten the collets nut without inserting a bit,
or the collets cone will break.
• Use only the wrenches provided with the tool.
Insert the bit all the way into the collet cone and
tighten the collet nut securely with the two wrenches
or by pressing the shaft lock and using the provided
wrench. To remove the bit, follow the installation
procedure in reverse.
Fig,4
1.Tighten
2.Loosen
3.Hold
- 6 -
min
- 1
12,000
14,000
17,000
22,000
27,000
30,000
Fig,5
1.Tighten
2.Loosen
3.Shaft
Publicidad
