Publicidad
CT230
•
Make sure the two tanks are empty (if necessary, empty them, see relevant section),
then unscrew the safety knob (fig. C, ref. 1).
•
Lift the tank assembly and rotate it inwards, providing access to the battery
compartment from the top (fig. C, ref. 2).
The tank assembly (CT 230) MUST ALWAYS BE raised using the handles
incorporated in the tank (fig. C, ref. 3). Danger of crushing the limbs.
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
•
Place the batteries in the battery compartment in the direction shown in the diagram
on the compartment.
Mount the batteries on the machine using lifting means suitable for their weight.
The positive and negative poles have different diameters.
•
Referring to the wiring layout shown in the above diagram, connect the battery cable
and bridge terminals to the battery poles.
diagram, tighten the terminals on the poles and cover with Vaseline.
•
Lower the tank assembly into the working position
The tank assembly (CT 230) MUST ALWAYS BE lowered using the handles
incorporated in the tank (fig. C, ref. 3). Danger of crushing the limbs.
When the tank assembly (CT230) is raised, the gas spring on the left side of the
machine (fig. T) must be locked in place by turning the green ring to the closed
padlock position to prevent the tanks from closing accidentally.
•
When using the machine, follow the instructions below.
5.4.3. Batteries: removal
When removing the batteries, the operator must be equipped with suitable personal
protection devices (gloves, goggles, overalls, safety shoes, etc) to reduce the risk
of accidents. Make sure the switches on the control panel are in the "0" position
(off) and the machine is turned off. Keep away from naked flames, do not short
circuit the battery poles, do not cause sparks and do not smoke. Proceed as
• disconnect the battery wiring and bridge terminals from the battery poles.
• if necessary, remove the devices fixing the battery to the base of the machine.
• lift the batteries from the compartment using suitable lifting equipment.
! DANGER
! DANGER
IMPORTANT
Arrange the cables as shown in the
! DANGER
! DANGER
! DANGER
follows:
ENGLISH
11
Publicidad
