Publicidad
Idiomas disponibles
Idiomas disponibles
5.2 Sterilising
Before sterilising, always clean as
described in chapter "5.1 Cleaning" on
page 20.
Warning!
during sterilisation.
Caution!
• Dismantle
each
individual components for boiling or
steam-sterilising (temperature above
80 °C) and leave open – otherwise
deformation can result.
• The operating unit 17 and the USB
cable 14 should never be sterilised in
this
way
deformation
electrical contacts.
• Incorrect treatment can damage the
parts.
• Before using again, always allow the
sterilised
parts
properly and dry completely before
reassembling.
6.1 Selecting the silicone
breast shield
The silicone breast shields 1 provided
are marked on the outside as follows:
24 mm and 27 mm. This refers to the
diameter at the narrowest point.
From the two silicone breast shields
select the one that best suits the size of
your nipple. Its diameter should be
slightly larger than your nipple. Then set
aside the breast shield that is not the
right size to rule out any confusion.
6.2 Expressing with one
breast shield
1. Assemble the device as shown in
figure B, steps 1 to 7.
Risk
of
scalding
part
into
as
it
would
and
damage
to
cool
6 Assembling the pump
• Do not use any chemical disinfectants
for sterilising:
its
1. Use
following the instructions for use of
the device;
Or
2. Sterilise the parts in boiling water for
5 minutes.
cause
Ensure there is sufficient water in the
the
pan to avoid damage.
Or
3. Use a NUK Micro Express Plus
Microwave
sterilisation in a microwave oven.
down
Only use the NUK Micro Express
Plus Microwave Steam Steriliser for
microwave sterilisation. Follow the
instructions for use of the device.
2. If you are expressing with only one
breast shield but are using the three-
arm tube set 16 for the double pump,
you must insert the unused tube in
the cross-piece to prevent any air
being drawn in there.
Note: The bottle adapter 9 provided
also allows you to use the breast pump
with bottles from the NUK First Choice
range.
Note: Make sure that the silicone breast
shield 1 fits snugly with the connecting
element 5 and that the flow valve 6 is
mounted properly as the pump may
otherwise draw in air, so preventing it
from working correctly.
21
a
NUK
Steam
Steam
Steriliser,
Steriliser
for
Publicidad
