Stimulation mode
Compari-
Simulation of the ini-
son with
tially fast feeding phase
breast-
of babies from the
feeding
breast when satisfying
their thirst. Duration 2
minutes.
Symbol in
display
Number
of levels
Select
level
3. Touch the on/off button 23 again to
stop the pump and switch to pause
mode.
To switch the pump off altogether,
touch the on/off button 23 for at least
2 seconds.
Automatic switch-off
If you do not use the breast pump for
more than 30 minutes, it will switch off
automatically.
8.2 Expressing milk
Warning!
hygiene is particu-
larly
please wash your
hands thoroughly
before expressing
milk.
8.2.1 Using a single pump
1. Position the silicone
breast shield 1 on
your breast so that
your nipple is in the
middle. Gently press
the silicone breast shield in place to
ensure a good seal for expressing
your milk. When doing so, keep the
breast milk container 7 attached to
the silicone breast shield in an
upright position.
2. Touch the on/off button 23 again.
The
stimulation mode, with the
suction strength at level 1.
The suction strength is shown on the
display 18.
Caution: Begin with suction strength
level 1 and then increase as required.
9
Using the 21 + and 22 - buttons
As
important,
device
starts
Suction mode
Simulation of the sec-
ond feeding phase of
babies. Drinking more
calmly in longer cycles.
9
We recommend going down a level if
expressing milk is painful.
3. Use the 21 + and 22 - buttons to
select an intensity that you find
agreeable from the 9 levels.
The suction strength selected is
shown in the level indicator 18.
4. If required, increase the suction
strength with the plus button 21 or
reduce it with the minus button 22.
The suction strength selected is
shown in the level indicator 18.
5. If required, increase the suction
strength with the plus button 21 or
reduce it with the minus button 22.
The suction strength selected is
shown in the level indicator 18.
6. If you notice that your flow of milk is
decreasing, touch the M 20 mode
button to switch to drain mode (see
"8.1 Switching the pump on and off,
selecting the mode" on page 22).
7. Use the 21 + and 22 - buttons to
select an intensity that you find
agreeable from the 9 levels.
The suction strength selected is
in
shown in the level indicator 18.
8.2.2 Using a double pump
1. Proceed as described in the previous
section for the single pump.
2. However switch the pump on first.
23
Drain mode
When the flow of milk
decreases, babies feed
faster again to stimulate
the flow of milk once
again.
9
The
device
automatically
suction
mode
2 minutes.
will
switch
to
after