Uline H-10948 Manual De Instrucciones página 3

MACHINE COMPONENTS
Carrying Handle
3-Speed
Switch
Air Outlet
Vent
Figure 4
NOTE: Telescoping handle and wheels are
included with H-6500. To use, push in release
button and pull handle up until it locks into
place. Tilt the unit back onto the wheels and
roll to desired location.
MACHINE MAINTENANCE
To keep machine in good working condition, perform
the following maintenance procedures.
Unplug cord from outlet when not in use and before
servicing machine.
1. Inspect power cord for damage after each use.
Replace power cord immediately if damaged.
2. Clean machine with a damp cloth.
3. Check for dust accumulation around the air inlet
and outlet vents and clean if necessary. Blocked
vents will cause the motor to overheat and may lead
to premature failure. Warranty claims for this type of
damage will not be accepted.
PAGE 3 OF 9
OPERATING INSTRUCTIONS CONTINUED
Power
Cord
Storage
Air
Intake
Vent
Kick Stand
1-800-295-5510
Unplug cord from outlet when not in use and before
servicing machine.
If machine fails to operate:
• Check power cord for damage.
• Check plug connection.
• Check building circuit breaker.
• Thermal sensor shutoff – wait 15-30 minutes to cool.
• Contact Uline Customer Service.
STORING AND TRANSPORTING MACHINE
Neatly wrap power cord and store machine in a cool,
dry area. Do not expose to rain. Store indoors.
Stack machines for storage. (See Figure 5)
CAUTION! Do not stack beyond four high
Do not stack during transport and secure
with strap.
uline.com
Figure 5
0623 IH-10948