SUHNER ABRASIVE SMH 60-SE Documentación Técnica página 13

2.1.3 d /c
etAching onnecting the collet chuck
Remove tool or clamping pin (see 2.1.2).
3
Loosen and remove the allen screw from the small ring
with the allen key (1). Block the collet chuck shaft with the
locking pin (2). Turn the collet chuck shaft using the collet
chuck key (3) until the pin locks into place. Completely
unscrew the collet chuck and remove it (anti-clockwise
motion). Clean the collet chuck and the clamping cone
before they are reassembled. Reassemble by following
these instructions in reverse, ensure that you tighten the
collet chuck without using excessive force.
Never tighten chuck collets without a tool or
clamping pin.
2.2 r
Ating dAtA
Power Input
Max. torque
Max. speed
Collet chuck EMA
Noise level at 50'000 min -1
Vibration EN 60745
Insulation class
Weight
Dimensions
2.3 o
perAting conditions
Temperature range during operation: 0 to +50°C
Relative air humidity: 95% at +10°C not condensed
3. h
aNDlINg
3.1 w
orking instructions
To achieve an optimum grinding result, move grinding
tool uniformly back and forth with light pressure. Exces-
sive pressure lessens the working capability of the hand
tool, as well as the life of the grinding tool.
3.2 s
Hold the hand tool firmly. Switch on the control unit.
hand tool must always be held in your hand. Switch OFF
the control unit when work has been finished. The tool will
continue to run for a while after the hand tool has been
switched OFF. Put the hand tool down safely, so that no
1
hazards can occur.
2
4.1 p
4.2 s
See page 2-3.
4.3 r
If despite strict observance of the manufacturing and test-
ing method the hand tool should happen to fail, it must be
repaired by an authorized SUHNER agency.
max. 280W
4.4 w
7.8Nm
1
50'000 min- In the event of the tool being improperly handled, used
2.35mm / 3mm / 1/8" for purposes for which it is not intended and/or of the ser-
59.8dB(A) vice and maintenance instructions not being observed by
2 2
<2.5m/s , K=1.3m/s non-authorized persons, no warranty shall be in effect for
IP54 damages/consequential damages. Complaints can only
0.365kg be honored if the hand tool is returned in the undisas-
Ø30x170mm sembled condition.
4.5 s
Temperature range: -15°C to +50°C
Max. relative air humidity: 90% at +30°C
4.6 d
This hand tool consists of materials which can be dis-
/o
PERaTIoN
posed of in a recycling process. Before disposal, render
the hand tool unusable.
must be disposed of in an environmentally-compatible
recycling process.
on/off
witching
Perform a test run where the tool runs without load
for at least thirty seconds. Do not use the grinding
tool if it is vibrating. When it is in operation, the
4. S /m
ERvIcE
reVentiVe mAintenAnce
Always keep the hand tool clean and in a dry
place. Worn collet chucks must be replaced.
pAre pArts
epAir
ArrAnty
torAge
/ e
isposAl nVironmentAl compAtiBility
Do not throw the hand tool into the garbage collec-
tion.
According to national regulations this hand tool
aINTENaNcE
13