Craftsman 126.32561 Manual Del Operador página 38

NOTE: The chart below references a compound cut for Crown Molding ONLY WHEN
THE ANGLE BETWEEN THE WALLS EQUALS 900
KEY BEVEL MITER TYPE OF CUT
SETTING SETTING
Inside Corner-Left side
1) Position top of moulding against fence.
IL 33.9 o 31.6 ° Right 2) Miter table set at Right 31.6 °
3) Left side is finished piece.
Inside Corner-Right side
1) Position bottom of moulding against
IR 33.9 o 31.6 o Left fence.
2) Miter table set LEFT 31.6 °
Outside Corner-Left side
OL
33.9 o 31.6 ° Left
1) Position bottom of moulding against
fence.
2) Miter table set at Left 31.6 o
3) RIGHT side is finished piece.
Outside Corner-Right side
1) Position top of moulding against fence.
OR 33.9 o 31.6 ° Right 2) Miter table set at RIGHT 31.6 °
3) RIGHT side is finished piece.
38