OPERATING AND MAINTENANCE MANUAL
MAINTENANCE
L Ordinary and extraordinary maintenance
must only be performed by specialist
personnel. If the paintwork is damaged
during maintenance, the customer must
restore it with the same type of paint (contact
Paoli for specifications). ATTENTION: the
thickness of the paint must not exceed
2mm.
L At regular intervals, top up with the addition
of lubricant in order to keep the appliance
efficient and to prolong its life.
L Use only original spare parts and only
authorised service organisations. Do not
perform
maintenance
improper tools. Use the annexed exploded
view drawing with spare parts list.
L Indicate the parts most subject to wear, to
be disassembled and checked at regular
intervals, as well as any list of malfunctions
and corrective actions.
L Do not damage the seals. Check the correct
positioning of the seals during reassembly
after the maintenance operations.
DEMOLITION
Separate the components according to the nature of the materials they are made of.
Translations of the original operating instructions
L Periodically (every three weeks) operate the
L Periodically (every four weeks) perform
operations
with
L Prepare a register in which to keep a note
L If the tool is left idle for long periods, it is
- The original language of these instructions is Italian.
impact wrench clockwise and anticlockwise
introducing into the air inlet special oil
for Paoli impact wrench motors (~5cc)
or very thin oil for pneumatic tools.
figure
Fig.6). These operations must be
performed in a suitable environment set
up for the suction of nebulised particles.
Use
appropriate
equipment.
the check on and maintenance of the
motor bearings, the transmission shaft
and greasing of the hammer mechanism.
Use
appropriate
equipment.
of the maintenance events and the related
deadlines.
advisable to introduce oil into the air intake
and let it run for a few seconds before
putting it away. The internal parts will thus
remain lubricated.
ENGLISH
ATEX RANGE
(see
personal
protection
personal
protection
17