Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS
REQUIRED
(not included)
• Phillips screwdriver
• 3/8" and 7/16" wrenches
ATTACH LEG MOUNTING
RAILS (Figs. 1 and 2)
Assembly Hint: It may be easier to attach
the leg mounting rails if you stand the
tabletop on its back edge for this step.
1. From the top side, insert three 1/4-20 x
2" button-heed machine screws (25)
through the holes at the rear of the
tabletop (1) and through a leg
mounting rail (3) (Fig. 1 ). The dimpled
holes in the leg mounting rail should
face away from the tabletop,
2, Secure with a 9/32" I.D. x 3/4" O,D.
washer (19) and a 1/4-20 KEPS nut
(17) on each screw.
3. From the top side, insert two 1/4-20 x
2" button-head machine screws (25)
through the holes at the front of the
tabletop (1) and through a leg
mounting rail (3) (Fig. 2). Position the
two offset holes in the sides of the
mounting rail on the left side of the
table, and the dimpled holes in the leg
mounting rail should face away from
the tabletop.
4. Secure with a 9/32" I.D. x 3/4" O.D.
washer (19) and a 1/4-20 KEPS nut
(17) on each screw.
LEVEL THE TABLETOP
For optimal routing performance, the tabletop
must be flat from side to side,
Lay a straight edge across the tabletop to
check that the tabletop is flat and level.
If it is not:
a) If the tabletop is higher in the center than
the ends, remove the nuts, washers, and
screws at each end of the rear leg
mounting rail, and insert a 9/32" I.D.
x 3/4" O.D. washer (19) between the
leg mounting rail and the tabletop at
each end. Reinstall the screws, nuts
and washers.
'url '
Figure 2
b) If the tabletop is higher at the ends than
the center, remove the nut, washer, and
screw at the center of the rear leg
mounting rail and insert a 9/32" I.D.
x 3/4" O.D. washer (19) between the
leg mounting rail and the tabletop in
the center. Reinstall the screw, nut,
and washer.
12
Publicidad
