4. Cleaning (cont.)
Breast pump – cleaning and disinfection
10
Clean and disinfect the breast pump as needed.
1. To clean the breast pump, wipe the pump housing with a clean, damp (not wet) cloth. Drinking-quality-
water and a basic washing-up liquid or non-abrasive detergent may be used.
2. To disinfect the pump, wipe the pump housing with a clean, damp (not wet) cloth that is impregnated
with a surface disinfectant agent for medical devices. Medela recommends using an alcohol-based
surface disinfectant agent.
Cleaning pump sets
Refer to the instructions for use provided with the Symphony pump sets for product description and
instruction on handling.
5. Preparing for pumping
Refer to figure ¢3 on the foldout pages.
• Only use the power cord that comes with the Symphony breast pump.
• Make sure the voltage of the power cord is compatible with the power source.
Optional for pump with battery:
• The built-in battery must be charged for 12 hours on receipt of the device.
• The pump can be used during charging.
• If the pump is to remain unused for a long time, charge the battery every two months (for 12 hours each
time).
• The optimum service life of the battery is achieved if it is not fully discharged on a regular basis or if the
pump is charged while not in use.
Pumping time (fully charged battery): approx. 60 minutes
Charging time (for full charge): 12 hours
5. 1 Installation of the program card. Installation of the card and
cord protector (optional)
Installation of the program card:
1. The program card must be inserted in the card compartment on the back of the breast pump ( ¢ 3-01).
Æ For more information on the use of the program card and the selection of the appropriate program, see
section 6.2.
WARNING
i
Information