Troubleshooting
Problem
The light will not come on.
The light comes on during the
day.
The light comes on for no
apparent reason.
Possible Cause
□
The light switch is turned off.
□
The fuse is blown or the circuit breaker
is turned off.
□
Daylight turn-off (photocell) is in effect.
□
The circuit wiring is incorrect, if this is
a new installation.
□
The motion sensor is aimed in the
wrong direction.
□
The outside air temperature is close to
the same as a person's body heat.
□
The motion sensor may be installed in a
relatively dark location.
□
The "ON-TIME" switch is in the "TEST"
position.
□
The motion sensor may be sensing
small animals or automobile traffic.
□
The "SENS" dial is set too high.
□
The "DUALBRITE" switch is in the 6
hour.
□
The outside temperature is much
warmer or cooler than a person's body
heat (summer or winter).
□
The motion sensor is wired through a
dimmer or timer.
9
□
□
□
□
□
□
□
□
□
□
□
□
□
Please contact 1-866-308-3976 for further assistance.
Solution
Turn the light switch on.
Replace the fuse or turn the
circuit breaker on.
Recheck after dark.
Verify the wiring is correct.
Re-aim the motion sensor
to cover the desired area.
Increase the "SENS" set-
ting.
The motion sensor is oper-
ating normally under these
circumstances.
Set the "ON-TIME" switch
to the 1, 5, or 20 minute
setting.
Re-aim the motion sensor.
Decrease the "SENS"
setting.
The motion sensor is oper-
ating normally under these
circumstances.
Decrease the "SENS"
setting.
Do not use a dimmer or
timer to control the motion
sensor. Replace the dimmer
or timer with a standard on/
off wall switch.
HOMEDEPOT.com