Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLING
CHUSEL AND BIT
Make sure that the machine is disconnected from the
power source.
ChbeUs are very sharp and can cause a serious cut.
Take extreme caution when handling chiseUs.
Figure
15
Figure
17
/J
//
/
/ _'i
1.
Insert bit (A) into chisel (B). See Figure 15.
B
3,
Lower chiseU 1/16" to 3/16" and tighten set screw.
There must be a space of 1/16" to 3/16" cbarance
(G) between the bushing (H) and shouUder of
chiseU (U)as shown in Figure 17. This assures
having proper clearance between the cutting edges
of the bit and points of the chiseUafter the bit is
inserted into the chuck.
Figure
16
E
}
/
/
/
/
/
J
/
/
/
/
/
/
C
Figure
18
/
/
K
[
[
[
i
[
[
2,
Loosen set screw (C) and push chisel (D) up
through hole in head (E) as far as possible, making
sure that the opening in the chisel (F) is facing to
the left or right. See Figure 16.
4,
14
Push bit (J) up through the chisel and into the
chuck (K) as far as it will go and lock bit into chuck
using the supplied chuck key, See Figure 18,
Publicidad
