Publicidad
Idiomas disponibles
Idiomas disponibles
Startup
-
Fill the pump with water to make sure that the pump body, filter basket, pipes
and other connectors are not leaking. Tighten or loose the screws with hands,
or tolls if necessary.
-
Open any existing valves in pressure and suction lines and check that all hoses
are connected
-
Please fill the suction pipe and the pump body completely with water.
-
Plug in the pump and check that the water pump circulates.
-
If the pump is used above the water level of the pool, you have to use a foot
valve at the suction hose to avoid that the water runs back in the pool when you
do not use the pump.
Switch of the pump, when the engine does not start or not water is promoted. In
this case check if something is blocking the water flow.
-
Do not run the pump without water in the pump body. This would damage the
mechanical seal and in this case the pump would leaking. Please do not work
on the pump while the pump is running!
-
If you have any problems which are not mentioned in the manual or which you
could not explain, please contact an expert.
Maintenance
Our electric pumps require no special maintenance. Please clean regularly the dirt
container. During the cold season, and at longer shut-down of the pump the pump
body should be emptied. Please clean the pump thoroughly with clean tap water to
remove all residues of chlorine and other pool stuff. If you do not clean the pump
thoroughly this could damage the seal and causes leaks when you use the pump
again.
Specification
Item
14650/SPPE200 230V/50HZ
Voltage
Power
HMAX
1200W
17M
QMAX
450L /MIN
Publicidad
