Publicidad
Idiomas disponibles
Idiomas disponibles
5.4
Fitting / removing the depth gauge (optional)
When driving screws with a sealing washer, use a depth gauge suitable for the diameter of the sealing
washer (accessory). When the depth gauge is correctly adjusted the screw seal will be correctly
compressed.
The depth gauge is attached to the metal construction screwdriver by way of a snap-on connection
and can be simply pulled off or pushed on.
▶ Fit the depth gauge.
5.5
Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (switch-on
interlock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.6
Fitting / removing belt hook (optional)
The belt hook enables you to attach suitable power tools to your belt. It can be fitted to allow attachment on
the left or right side of the body.
CAUTION
Risk of injury by falling power tools!
▶ Check that the belt hook is fitted securely before beginning work.
1. Insert the belt hook into the installation opening for accessories.
2. Secure the belt hook with the screws provided.
3. Check that the belt hook is secure.
4. To remove the belt hook, remove the screws and pull the belt hook out of the installation slot for
accessories.
5.7
Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap #2293133 and the Hilti
tool tether #2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
5.8
Setting the torque
▶ Set the desired torque.
*2383935*
3
4
5
2383935
2
English
9
Publicidad
