Publicidad
Idiomas disponibles
Idiomas disponibles
1
Safety Notes
FCC-Statement (Class A, Group 1)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause interference, and 2) this
device must accept any interference received, including interference that may cause
undesired operation.
Federal Communications Commission Statement
NOTE – This equipment has been tested and found to comply with the limits for a Class A ,
Group 1 digital device, pursuant to Part 15 of the FCC Rules. These limit values were designed
to provide adequate protection against faults occurring during operation in industrial areas. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be deter-
mined by tuning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/television technicians for help.
Class A, Group 1 Note
Warning – This is a Class A, Group 1 product. In a domestic environment this product may
cause radio interference in which case the user may be required to take adequate measures.
Warnings
This device complies with Part 15 of the FCC rules and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interfer-
ence received, including interference that may cause undesired operation. The manufacturer is
not responsible for any radio or TV interference caused by unauthorized modifications or change
to this equipment. Such modifications or change could void the user's authority to operate the
equipment.
This radio transmitter (identify the device by certification number or model number if Category II)
has been approved by Industry Canada to operate with the antenna types listed below with the
maximum permissible gain indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this de-
vice.
Antenna Type
internal permanent antenna
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protec-
tion against harmful interference when the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful in-
terference in which case the user will be required to correct the interference at his own expense.
CAN ICES-003(A)/ NMB-003(A).
The device has been evaluated to meet general RF exposure requirement. The SAR limit of
USA (FCC) and Industry Canada is 1.6 W/kg averaged over one gram of tissue. Device types
ROCAM mini HD with ROCAM mini HD-Basis AMP
(FCC ID: 2AADC-RCMA, IC: 11124A-INS004A) has also been tested against this SAR limit.
The highest reported SAR values for body-worn is 0.385W/kg. This device was tested for typical
Max. Antenna Gain(dBi)
4.0
ENGLISH
15
Publicidad
