IKEA MITTZON Manual Del Usuario página 5

Handset operation instructions:
Function and status Operating Buttons
Up Up button
Down Down button
Locking Up button+Down
button
Unlocking Up button+Down
button
Set memory position 1 Memory 1 button
Set memory position 2 Memory 2 button
Memory 1 position Memory 1 button
Memory 2 position Memory 2 button
Reset Pin hole +Down button
Abnormal error status Pin hole +Down button
Overheat protection /
status
Collision detection
• The system is designed to avoid possible damages to equipment due to collision. When the desk detects a sudden change in resistance, it will stop the
movement and move in the reverse direction by approximately 30 mm-50 mm (depends on the movement speed, collision force and the load during collision).
Operation method Button press
duration time
Long press /
Long press /
Long press together 3 sec
Long press together 3 sec
Long press 3 sec
Long press 3 sec
/ One click
One click /
1 click the pin-hole /
first, then long
press down button
Reset operation /
Rest for approx. /
18 minutes
before continuing
operation of unit
Light colour Light Note
display
effect
No light / /
No light / /
Red light Blinks 1. After the locking setting is complete, the red light
blinks twice and then turns off.
2. No light is displayed when the unit is locked.
3. In the locked position, press any button and the red
light will blink 1 time to indicate the locked status.
Green light Blinks 1. After the unlocking setting is complete, the green light
blinks twice and then turns off.
2. No light is displayed during unlocking.
White light Blinks 1. After the setting is complete, the white light blinks
twice and then turns off.
2. No light is displayed during the setting.
White light Blinks 1. After the setting is complete, the white light blinks
twice and then turns off.
2. No light is displayed during the setting.
No light / Please ensure there are no obstacles under or above the
table before Memory 1 position is set.
No light / Please ensure there are no obstacles under or above the
table before Memory 2 position is set.
Orange light Steady on First, poke the pinhole at the bottom of the hand
controller with a pin to enter the reset status (at this
time, the orange light will be steady on), and then long
press the down button until the table goes down to the
lowest height, and then raise it up 7 mm automatically
to complete the reset. After the reset is successful, the
orange light will turn off.
Orange light Blinks In the abnormal status, the orange light continues to
blink. Pressing any button does not work. You need to
check if all the cables are properly connected, and then
perform the reset.
Blue light Steady on This is not an abnormal error status, but due to the
motor working continuously, overheat protection may
activate. After approx. 18 minutes of rest, the blue light
will turn off and normal operation can be resumed.
5