Publicidad
U
x 26
FIG. 10
10. Attach Back (H) to unit, flush with bottom and centered side to side. Use #6 x 1/2" Philtruss
Screws (U) in the predrilled holes.
W
x 4
FIG. 11
11. With the Door laying face down on a clean protected surface, place a Hinge (Q) in each large
hole in the back of the door. Line up the screw holes in the hinge with the predrilled holes in the
door and insert #6 x 3/4" P.O. Screws (W).
DECIDE WHICH WAY YOU WOULD LIKE THE DOOR TO OPEN.
There are prepunched holes on the inside edge of both sides for attaching the hinges.
12. Holes are predrilled in each side to mark the locations of the screws for each Hinge Spacer (S)
and Hinge Plate (R). Since it may be difficult to see the punches through the hinge spacers we
recommend that you start a #7 x 1½" Type 17 Screw (X) into each punch to make the hole easier
to see. Remove the screw and insert through the Spacer (S) and Hinge Plate (R). With the long
arm facing out, fasten each set in place.
Page 8 — 744W
U
H
Q
Hinge
Arm
W
W
U
U
U
X
X
X
DOOR
U
Stain Test Area
x 4
R
FIG. 12
Side
S
Publicidad
