ST MP 500 Li 48 Manual De Instrucciones página 133

• If necessary, release the clip buckle (Fig. 12.C)
to remove the machine from the harness.
6.1.3 Filling with chain lubrication oil
Fill with chain lubrication oil before using
the machine. For oil filling methods and
precautions (see paragraph 7.3).
6.1.4 Checking the chain tension
Perform all operations
with the motor off.
Check the chain tension.
The tension is correct when the drive links
do not slip out of the chain guides if you hold
the chain in the middle of the bar (Fig. 7).
To adjust the chain tension:
1. loosen the guard knob (Fig. 3.A).
2. turn the chain tension adjuster screw (Fig.
5.D) to achieve the desired tension;
3. raise the bar and tighten the
knob securely. Fig. 8.A).
Never work with the chain loose,
as it can be hazardous if the chain
slips out of the bar guides.
IMPORTANT During the first period of use
(or after replacing the chain) it must be checked
more frequently due to settling of the chain.
6.2 SAFETY CHECKS
Run the following safety checks and
check that the results correspond to
those outlined on the tables.
Always carry out the safety
checks before use.
6.2.1 General safety check
Object
Grip and guards
Screws on the
machine and blade
Cooling air ducts
Guide rod
Chain
Guards
Result
Clean, dry and fixed
firmly to the machine.
Correctly tightened
(not loose)
Not clogged
Properly installed
Sharp, not damaged
or worn, mounted and
tensioned correctly.
Intact, undamaged.
Battery
Machine
Throttle trigger lever,
throttle lock lever
Test
driving
6.2.2 Machine operating test
Action
Fit the battery inside
its housing (par. 7.2.3).
Activate the throttle
trigger lever. (without
pressing the throttle
lock lever)
Press the throttle
lock lever and throttle
trigger lever.
Release the throttle
trigger lever.
If any of the results fail to match the
instructions provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.
6.3 START-UP
1. Remove the protection bar cover (Fig. 1.J).
2. Make sure the bar and the chain are not
touching the ground or any other object.
3. Fit the battery inside its housing
correctly (par. 7.2.3).
4. Press the safety button
5. Activate the throttle lock lever (Fig. 11.B)
and the throttle trigger lever. Fig. 11.A).
6.4 WORKING
Before delimbing for the first time, make sure:
– to have been specifically trained
to use this type of equipment;
– to wear the harness correctly;
– to have carefully read the safety
regulations and user instructions
contained in this manual;
EN - 9
No damage to
the casing, no
liquid leakage
No signs of
damage or wear
The levers must
move freely and
not be forced.
No abnormal
vibrations.
No abnormal sound
Result
The chain should
not move
The throttle trigger
lever remains blocked.
The levers must
move freely and
not be forced. The
chain moves.
The lever automatically
and rapidly returns
to the idle position.
The chain should stop.
Fig. 11.C ;
( )