JMA SUPRACODE Manual De Instrucciones página 34

C
3
2
1
3.4 KEY SIDE CLAMPING
There are some key models that, in addition to being cut on the front of the
blade, are also cut on the reverse.
In these cases, the clamp allows these keys to be clamped so that the reverse
can be cut or read.
The key may require clamping with a "collar stop" or "tip stop".
4.- TOOLS
4.1 CUTTER REPLACEMENT
1) Lift the transparent protector from the machine.
2) Turn the cutter clamping lever (T7) with one hand anticlockwise (towards
OPEN) in order to open the head's internal chuck and release the cutter (F).
At the same time, remove the cutter (F) with the other hand by pulling it
downwards.
3) Insert the new cutter (F) into the cutter-holder (T6) opening until it reaches
the internal stop.
VERY IMPORTANT: before inserting the new cutter (F), ensure that its tip
is free of swarf. To do this, it is recommended to clean it using a brush or
pressurised air gun.
34
COLLAR
TIP STOP (1-2-3)
4) Continue to push the cutter (F) against the internal stop, rotate the cutter
clamping lever (T7) clockwise (towards CLOSE) in order to close the internal
head chuck and thus clamp the cutter (F).
T7
4.2 TOOL MAGAZINE
The SUPRACODE machine has a tool magazine where a maximum of 12 cutters
can be stored in an orderly way.
Below is a list of its different parts.
1- Cutter-holder
2- Opening for the cutter-holder
3- LED lighting
4- Tray for accessories
5- Opening for cutter-holder in use
T6
F
5
4
3
2
1