ASSEMBLY OF WHEELS AND ACCESSORIES
-
Assembling the castors: Remove the head, turn the tank upside down and snap the castors
on as shown in figure 5.
-
Fitting the foam filter: When sucking in water, the filter 15 must be fitted. It is placed like a
cap on the support 4 (see figures 3 and 6).
-
Fitting the dust bag: When vacuuming dry floor, the filter 14 must be fitted. It is placed on
the internal suction connection of the tank 7 (see figures 7). The dust bag can only be used
when vacuuming dry soil: do not use it when vacuuming water.
-
Assembling the suction hose: Proceed as shown in figure 8 for all suction operations;
connect the flexible tube 10 to the connection 9 for use in blower mode.
-
Rigid tubes 11 can be used to increase the length of the flexible tube 10 (Figure 9c).
-
Depending on the job required, fit brush 12 (Figure 9b) or nozzle 16 (Figure 9a).
-
Assembling the cable holder: position the cable holder hook 17 as shown in figure 10. At
the end of the work, the power cable of the hoover can be arranged as shown in figure 10.
USAGE
This hoover has been designed to suck up water and dust using the appropriate filters (foam
filter or dust bag).
Do not use it for the suction of combustible or explosive materials, or other hazardous materials.