Operation And Maintenance; Getting Started; Extension; Inspection - ENAR M35 AFP-M5 Manual De Instrucciones

4

OPERATION AND MAINTENANCE

4.1 GETTING STARTED

Read item 3 USAGE CONDITIONS
VIBRATING POKER CONNECTION TO CONVERTER
The poker has sockets to connect the vibrating pokers.
Firstly, connect the converter to the electrical supply; be sure that the connection is correct (specification
and condition of cable according to standards of security). Them switch on the converter, connect the
pokers and it will be available to switch on.
To disconnect, firstly switch off the vibrating pokers and then disconnect the converter with their switch and
finally remove the converter plug of the electrical supply.
Connection possibilities:
The input current of the pokers connected in load shall not exceed the out current specified in the
electrical characteristic table of the converter.

4.2 EXTENSION

Use three phase cables with the appropriate plugs.
Do not use damage or worn out cables.
Avoid heavy loads on cables.
en
To determine the transversal section, follow the next recommendation:
The allowed heating according to VDE standard requires the transversal sections according to the working
current (attached table).
I.e.For 20 A, according to the table for 26 A or less the section is 2,5 mm.

4.3 INSPECTION

1.
2.
detected, proceed to change to avoid bigger problems.
3.
6
M35 AFP-M5 AFP-M6 AFP-M7 AFP-M8 AFP
MP35 AFP-MP5 AFP-MP6 AFP-MP7 AFP
Minimum sections according to VDE rules
Line Maximum
mm
2
1
1,5
2,5
4
6
10
16
25
Therefore, the section chosen will be 2,5 mm
Before starting the job, check the correct working of all the handling and safety devices.
Inspect regularly the good conditions of the cables and the rubber housing. When a defect is
If defects are found in the safety devices or other defects, which could reduce the safe
handling of the equipment, stop working and notify to the proper responsible person.
Max. fuse
A A
15 10
18 10/3-16/1-
26 20
34 25
44 35
61 50
82 63
108 80
ELECTRIC VIBRATING POKERS