BGS technic 7710 Manual De Instrucciones página 4

PULLER BOLTS
USE
1. Chose suitable puller bolt. The size has to be chosen in accordance to the internal diameter of
the bearing to be pulled.
2. Push the puller bolt through the cone of the bearing so that the pulling edge of the bolt grabs
behind the bearing.
3. Adjust the diameter of the puller bolt to the internal diameter of the bearing by tightening the
puller screw.
4a. Install the slide hammer onto the adaptor screw and pull out the bearing by operating the slide
hammer carefully.
4b. Install the two-arm puller onto the adaptor screw and pull out the bearing by turning the spindle
of the two-arm puller.
A Puller screw
B Puller bolt
C Bearing
D Housing of the bearing
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Bolt
Nr.
5
4
3
2
1
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Diameter range (Ø B)
Min. Max.
6 mm 9 mm
8 mm 11 mm
12 mm 17 mm
18 mm 23 mm
24 mm 29 mm
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
Collar (Ø A)
Min.
7 mm
10 mm
16 mm
22 mm
28 mm